Hi Alessandro， For the quasi-3D simulation, a small perturbation should be applied at the initial stage, especially in the spanwise direction. At least for the w velocity component if you want to use a 2-D field for u,v and p components. Therefore, a Gaussian Noise generator "awgn(0.0001)" will help as, <FUNCTION NAME="InitialConditions"> <E VAR="u" VALUE="awgn(0.0001)" /> <E VAR="v" VALUE="awgn(0.0001)" /> <E VAR="w" VALUE="awgn(0.0001)" /> <E VAR="p" VALUE="awgn(0.0001)" /> </FUNCTION> Hope it works! Cheers, Chengjiao ===================================== 任珵娇；Chengiiao Ren， 博士研究生；Ph.D Candidate， 建设工程学部；Faculty of Infrastructure Engineering， 大连理工大学； Dalian University of Technology， 大连，中国 116024；Dalian，CHINA 116024. 电话，Phone：86-18504285808，61-413077330 电子邮箱，Email：dlut_renchengjiao@163.com; chengjiao.ren@outlook.com; ===================================== At 2021-02-22 18:15:31, "Alessandro Alberto de Lima" <aalima@usp.br> wrote: | This email from aalima@usp.br originates from outside Imperial. Do not click on links and attachments unless you recognise the sender. If you trust the sender, add them to your safe senders list to disable email stamping for this address. | Hi. I am trying to run a simulation of a flow past a cylinder. I am using the mesh of the flow stability analysis tutorial and my results are completely two dimensional. No three dimensionalities are present. The xml is attached to this message. Can anyone check if I missed something or what I did wrong? Thanks. Alessandro