num=33
FieldConvert -m vorticity compressor.xml conditions3d.xml compressor_${num}.chk ${num}.chk
FieldConvert -m C0Projection compressor.xml conditions3d.xml ${num}.chk ${num}s.chk
FieldConvert compressor.xml conditions3d.xml ${num}s.chk ${num}s.plt
It will convert compressor_33.chk to an appropriate file for post-processing. Note that you must use appropriate mesh and high polynomial order to achieve good-looking results (see figure below)
CAUTION: This email originated from outside of the University. Do not click links or open attachments unless you recognise the sender and know the content is safe.
|
This email from gongminjiang@hrbeu.edu.cn originates from outside Imperial. Do not click on links and attachments unless you recognise
the sender. If you trust the sender, add them to your
safe senders list to disable email stamping for this address.
|
Hello!
I want to generate Q-criterion and vorticity isocontour in Tecplot, and also I use C0Projeciton to smooth data, but the visualization quality is not
good. Do I still have some skills to make the isocontour smooth?
Best wishes!
This message is intended solely for the addressee and may contain confidential and/or legally privileged information. Any use, disclosure or reproduction without the sender’s explicit consent is unauthorised and may be unlawful. If you have received this message
in error, please notify Northumbria University immediately and permanently delete it. Any views or opinions expressed in this message are solely those of the author and do not necessarily represent those of the University. Northumbria University email is provided
by Microsoft Office365 and is hosted within the EEA, although some information may be replicated globally for backup purposes. The University cannot guarantee that this message or any attachment is virus free or has not been intercepted and/or amended.