This happens when you request a DG element (degree > 0) on an extruded quadrilateral mesh. Since there is an ambiguity (did you mean dQ or dPc?), the warning tells you that it picked the dQ element. If this is triggered from your user code, just write DQ instead DG or DP as the element family name. Otherwise you may try to lower the logging level for UFL, so these messages remain hidden. On 23/03/17 12:12, Buesing, Henrik wrote:
Dear all,
I am getting a lot of
/UFL:WARNING Discontinuous Lagrange element requested on quadrilateral * interval, creating DQ element/
Should I care? How can I deactivate these warnings?
Thank you!
Henrik
--
Dipl.-Math. Henrik Büsing
Institute for Applied Geophysics and Geothermal Energy
E.ON Energy Research Center
RWTH Aachen University
------------------------------------------------------
Mathieustr. 10 | Tel +49 (0)241 80 49907
52074 Aachen, Germany | Fax +49 (0)241 80 49889
------------------------------------------------------
http://www.eonerc.rwth-aachen.de/GGE
hbuesing@eonerc.rwth-aachen.de
------------------------------------------------------
_______________________________________________ firedrake mailing list firedrake@imperial.ac.uk https://mailman.ic.ac.uk/mailman/listinfo/firedrake